real flight 8

I have just got real flight x wireless interface and could not connect my dx8 to the sim does any one have any ideas why this could be.

Do you mean the Real flight is not finding the DX8?
Or not connecting?

You need to tell us what you have done so far.

In the meantime, I am assuming you are running Windows 10 on a PC.

When you plug in the interface lead into a USB port did the system say found new USB device?

I do run windows 10 and I'm not sew about it being found on a new usb device but the interface flashis red then turns of and is no light.

Follow this link from Real Flight. There are a number of reasons so you need to work through them gradually.
www.realflight.com/support/kb/article.php?q=01-1022

Hi Phil,

I am Jacob's dad.

What we have done is bought the wireless interface RF-X which Sussex Model Centre suggested. We have plugged it into the USB and attempted the binding process, but it did not work. The controller shows the orange light on which I believe means it is transmitting? On the wireless interface it has a red light which is flashing, if it successfully binds than it will go a solid red.

Any ideas?

KR's

Julian

Sorry, I should've read the post carefully. You are using a wireless interface ,not a hard wired lead. Not sure on this one but if the interface is transmitting then you need to go into the DX8 bind mode as if you were binding (pairing) a receiver.

Note: Interface is not compatible with version 6 or lower.
Oh, and ensure you are PPM mode on the Transmitter.

DX8 owners jump in here....

Edit: Have you selected from the Real flight menu Simulation (top left corner) and chose the transmitter you are using. That is a definitely a good start.