Dual Channels for Ailerons

Need a bit of help here Guys. The Beast has a servo for each of it's four wings. Left wing servos are y-leaded into the aileron channel. Right wings are y-leaded and are connected to aux 2. whicxh is mixed with aileron channel.

I have scoured the DSX9 manual for guidance but my issue is that when trimming the ailerons as you would in flight, only the left ailerons adjust. Surely the trim should affect both channels or have I missed a mix/click somewhere. I have also tried going into the device section under "wings" and "mating" the channels. That didn't work either!

I don't really want to patch all the aileron servos into one channel. The servos are mini metal so I assume the current draw on one channel wouldn't exceed the RX capability.

Sub-trims work okay for fine adjustment to make up for allowances in linkages.

Nearly ready Jon!

Phil

I'm not familiar with 9x programming, but JR standard is to have the second aileron plugged into the flap channel (port number 6) then set wing type to flapperon, the trim will then work for both sides. If for some reason you have to use Aux2, you should be able to select 'cross trim' (this is what it is called on the 10X, but it may be called something different on the 9X) in the mixer settings which transfers the trim across with the mix.

As Jon say's use port ali and flap, use flapperon mix, then "Y" lead left top and bottom wing to each other and then the same for the right!
Mechanically set the servo arms and links!

This is basically how I done it on my ultimate, simples

And same way I setup my Miss Wind on my 9XII. Phil did you get the email I sent you this morning? Talks through the flaperon mix.

Yes Dave, I have picked up your email. I'll follow the link. Cheers!

Phil
There are some good vid's on you tube showing how to program the dsx9 for setting up multiple servos

Pete