Inconsistent Tickover

  • Chris73
  • Topic Author
  • Offline
  • Platinum Member
  • Platinum Member
More
8 years 7 months ago #6090 by Chris73
Inconsistent Tickover was created by Chris73
Help needed please.

The last time I flew Chloe's Edge I noticed that I had to trim down a lot more than usual to get the idle low enough to land, on the ground the idle was all over the place. I stripped it down tonight and the servo seems to centre ok and all of the linkages are tight. There was a bolt missing from the manifold and the remaining bolt was loose, could this have caused the problem????

Please Log in or Create an account to join the conversation.

  • Visitor
  • Visitor
8 years 7 months ago #6093 by
Replied by on topic Inconsistent Tickover
Yes Chris, the back pressure in the exhaust would be all over the place the flanges could have been covering the ports with the viberation. :(

Please Log in or Create an account to join the conversation.

More
8 years 7 months ago - 8 years 7 months ago #6096 by JonTappin
Replied by JonTappin on topic Inconsistent Tickover
If the manifold was loose enough to be blowing past the gasket, which it probably was, then yes that will affect the idle, as you are losing exhaust back pressure.

Edit. Frank beat me to it :)
Last edit: 8 years 7 months ago by JonTappin.

Please Log in or Create an account to join the conversation.

  • Chris73
  • Topic Author
  • Offline
  • Platinum Member
  • Platinum Member
More
8 years 7 months ago #6102 by Chris73
Replied by Chris73 on topic Inconsistent Tickover
Thanks guys, manifold is now tight so hopefully problem solved :)

Please Log in or Create an account to join the conversation.

More
8 years 7 months ago #6103 by AlanF
Replied by AlanF on topic Inconsistent Tickover
Check the exhaust port faces for signs of hammering. When this happened to me I had to lap the face of the exhaust to get a decent seal again. Luckily the engine exhaust face was ok. I now use nordlocks and gasket sealant around the exhaust screws and things have remained tight so far.

Please Log in or Create an account to join the conversation.

More
8 years 7 months ago #6112 by JRI
Replied by JRI on topic Inconsistent Tickover
IMHO - watch out for the carburettor arm butting up to the manifold/casting at tickover especially on DLE engines. Caught me out!

Please Log in or Create an account to join the conversation.

Moderators: DaveBright
Time to create page: 0.304 seconds

Latest Posts