This could be fun

More
7 years 6 months ago #14254 by Chris73
Replied by Chris73 on topic This could be fun
Tonight's jobs will be to make the other wing (This is literally a 10 minute job) and then add the motor box

Should I use CA for this like the rest of the build, it would it be better to use 15 minute epoxy for this??

Also the leading edge of the wing is flat, should I try and round this off a bit or does it not matter??

Please Log in or Create an account to join the conversation.

  • Topic Author
  • New Member
  • New Member
More
7 years 6 months ago #14255 by
Replied by on topic This could be fun
Was sagen die Anweisungen Chris? :evil:

Please Log in or Create an account to join the conversation.

More
7 years 6 months ago #14256 by Chris73
Replied by Chris73 on topic This could be fun
Who knows, there in bloody German as well!!!

Please Log in or Create an account to join the conversation.

More
7 years 6 months ago #14257 by kevinross
Replied by kevinross on topic This could be fun
Personally, I was going to the local abatoir for some old horse hoofs to boil down and make some proper glue

but for ease of use i suppose epoxy sounds like a good idea.

Please Log in or Create an account to join the conversation.

More
7 years 6 months ago #14258 by MikeSeale
Replied by MikeSeale on topic This could be fun
Wing leading edge should definitely be rounded.
It probably makes little difference what glue you use, but the instructions for these Gruner kits usually have pictures of the type of glue recommended next to the description. As for the instructions, I have Microsoft translator installed on my phone...just point the phone at the instructions and you're done.
The following user(s) said Thank You: Chris73

Please Log in or Create an account to join the conversation.

More
7 years 6 months ago #14259 by Chris73
Replied by Chris73 on topic This could be fun
Thanks Mike, I better get sanding

Installed the translator app as well, will see how well it works when I get home

Please Log in or Create an account to join the conversation.

Moderators: DaveBright
Time to create page: 0.294 seconds

Latest Posts