Morris Dancer build

Take note of the slight error I made. The battery tray is notched to go just one way into the fuselage sides. Therefore make sure you glue the bracing tabs on the correct side.  As I found out!

I started with the tail surfaces first. Dry fit, then glue n pin.  Used lipos to keep flat whilst gluing the ply to the balsa (the balsa is on the outsides Kevin ) 

With the fuselage sides sorted I then inserted the battery tray after a few dry fits. I found 
I had to apply a little chamfers on the tray tags to get the tray to slide into the fuselage sides.  Once happy with the fit I fitted the F1 using epoxy and the lower bracing ply and the initial forward landing bear plate with Aliphatic.   I will leave this area open for now so I can easily access the firewall if I decide to fit 3mm spike nuts to secure the motor.  After a night of setting I then glued the tail skid plate. The fuselage is starting take shape.

After considering various covering solutions, have ordered solarfilm direct. (they still have considerable stock) 

Works out cheaper due to less waste because one width of 67cm covers a single wing span 

My progress so far in rather small workspace - a utility room (No chance of doing it in the house)

Ailerons were assembled on the glass (originally a cooker splash back) and then spent some hours flying at Cashmoor whilst glue sets.

Next morning, a modification regarding the elevator control wires.  Made up a 2mm ply former with two holes for the guide tubes 30 mm apart.  Image shows dry fit.

Having lots of motors but none suitable for this project I opted for the Ripmax Quantum II 25C 1000 kv.  A light motor capable of 3 or 4 cells.  The X plate mounting is a perfect fit to the kits laser cut holes in the firewall.