Extreme Flight 104" Extra

Chris73 wrote: Not much left to do now
Fit fuel dot
Fit switches and tidy up the wiring
Make the engine baffles
Silver solder the headers :dry:
Then check the C of G before locating the ignition battery

Apparently I have to tidy up before I do anything else :whistle:

Impressive stuff Chris - have you slept at all this weekend?
Are you going to send a snotagram to EF regarding the tail wheel? I'm sure they would welcome customer feedback.

Persuaded the missus it would be better to fit the fuel dot before I tidied up as it would just make more mess so that's one less thing to do.
I really should learn to tidy as I go, took me ages :oops:

Simon, yes I have the pipes already

Alan, whilst the tail wheel was a really bad fit in reality it only took a couple of minutes with the dremel to fix it. I wonder if I have a 50cc one instead of a 100cc one. I will compare it to Simon's and if need be ask EF for the correct one

Can't believe how slowly this has gone together..... Yawn

I of course jest. great stuff mate.

My HK spinner arrived today. Looks very nice. Not sure where to source a m6 bolt long enough to secure it ,Spinner is 7" long ? Any suggestions?

Mine came with the bolt, but you could try Westfield Fastners they seem to have a good selection

simondean wrote: My HK spinner arrived today. Looks very nice. Not sure where to source a m6 bolt long enough to secure it ,Spinner is 7" long ? Any suggestions?

Simon, are you sure it is m6? as they are normally m5