Sebart Mythos Throws

  • Topic Author
  • Visitor
  • Visitor
7 years 9 months ago #9270 by
Replied by on topic Sebart Mythos Throws
Thanks Jon, that looks like it will do.

Please Log in or Create an account to join the conversation.

More
7 years 9 months ago #9271 by 4Pedalsfly
Replied by 4Pedalsfly on topic Sebart Mythos Throws
Hi Guys - Am I missing something here, why not drill the rudder arm out at 40mm to match the servo arm ?
Is it perhaps to do with precise rudder movement ?

Colin

Please Log in or Create an account to join the conversation.

  • Topic Author
  • Visitor
  • Visitor
7 years 9 months ago #9272 by
Replied by on topic Sebart Mythos Throws
Alas Colin, I've epoxied in the horns into the rudder which is glued onto the fuselage so any drilling would be fraught with danger now.

Please Log in or Create an account to join the conversation.

More
7 years 9 months ago - 7 years 9 months ago #9273 by JRI
Replied by JRI on topic Sebart Mythos Throws

I have dead-center tool that would safely do the drilling job Chris .. also a set of pin-vices for small drills.
Attachments:
Last edit: 7 years 9 months ago by JRI.

Please Log in or Create an account to join the conversation.

  • Topic Author
  • Visitor
  • Visitor
7 years 9 months ago #9281 by
Replied by on topic Sebart Mythos Throws
Thanks John,

I didn't see your post until after I'd dived off in a different direction. Being a total cheapskate, I decided to go the DIY route
Attachments:

Please Log in or Create an account to join the conversation.

  • Topic Author
  • Visitor
  • Visitor
7 years 9 months ago #9314 by
Replied by on topic Sebart Mythos Throws
With servos with metal output shafts, do you loctite the arm retaining screw, or is the grippy washer enough?

By the what Jon & Chris, the jig for enlarging the hole in the tail worked well, 4.5 hours to design it, build it and test it. :evil:

Okay, I used masking tape, a steel ruler and a scalpel, but the jig would have been more precise!

Please Log in or Create an account to join the conversation.

Moderators: DaveBright
Time to create page: 0.737 seconds

Latest Posts