Minus Thermic

MikeSeale wrote: Having seen your "Christmas Story", all I'd say is "if the cap fits..."

MikeSeale wrote: Having seen your "Christmas Story", all I'd say is "if the cap fits..."

MikeSeale wrote: ...A solution would be to use very short elevator horns, but I had already cut them to 8mm and decided that even shorter would not be acceptable because:
1. Shorter horns would give limited 'grip' for the heatshrink and
2. Shorter horns would result in MORE elevator movement than needed and I would have to dial down the throw using travel limits, and this would reduce my resolution

So the elevators were removed and a couple of mm cut from the ends in order to increase the gap. With hindsight, only 1mm was needed